Performance Concrete

Retail Projects

Brookville Roadster

Brookville, Ohio

Building assembly: AAC block and panels were incorporated into this expansion's pre-engineered steel infrastructure and metal siding. AAC 8 inch block was used to complete the rear fire wall that was required between the existing and new space. AAC block and panels were used on the front facade of the building with 3 inch AAC cladding used to provide design details.

Exterior finish: Elite Cement's Litewall and Acyrtex system was used for the exterior finish of the new facade.

Type of expansion: The front of the new space will be used as a showroom for Brookville Roadster's custom hot rods. The rear of the new space will be used for

additional production for this rapidly growning enterprise.

Dealer/Contractor/Installer: Bruns General Contracting

Tipp City, Ohio

937-339-2300

Dale's Goodyear Tire Center

Tipp City, Ohio

Building Assembly: 8 inch load bearing AAC blocks and lintels were used to expand this existing retail facility.

Exterior finish: Elite Cement Products' Litewall base coat and Acyrtex finish coat was used on this expansion. The fine sand Acrytex finish allowed the expansion to match the existing EIFS finish of the rest of the retail strip center. This same finish was also applied over an existing brick veneer wall on the end of the facility that had begun to deteriorate. The ability of Litewall to bond to existing brick veneer and CMU allows clients to update the exterior appearance of their entire facility during expansions.

Type of expansion: Addition of five service bays to existing retail operation.

Architect: Don Kiley and Asso.

Dealer/Contractor/Installer: Bruns General Contracting

Tipp City, Ohio

Phone number: 937-339-2300

Building Assembly: 8 inch AAC panels attached to pre engineered steel structure.

Exterior Finish: Elite Cement Products Acryl M was used for the exterior finish of this new facility.

Design Build: Michael Lichtenberg and Sons Construction

Mooreman Pontiac

Building Assembly: 3 inch AAC cladding attached to 16 gage steel studs with #6 coarse thread screws.

Exterior Finish: Elite Cement Products' Litewall base coat with Acyrtex coarse sand finish.

Type of Expansion: This remodeling project was completed on the dealership's primary showroom building that was constructed in the late 1960's. The AAC cladding was used to construct a new, more modern facade the dealership.

Building Assembly: 38,000 sq. ft. of 8 inch AAC cladding attached to pre engineered steel structure.

Exterior finish: Acryl M was used for the majority of the exterior of this large sports facility located on Mt. Zion Road, exit 178, off of I-71. At the high traffic entrance and exit of the facility, the client choose to use Litewall and Acrytex 30 feet to either side of the doors. This finish was used as these locations due to its durability and resistance to chipping.

Interior finish: The client choose to simply paint the interior of the building with an acrylic latex paint to high light the color scheme he had selected for the steel and duct socks.

Building Assembly: This new 17,600 sq. ft.Honda Powersport facility is a structural steel building with CMU masonry infills.

Exterior Finish: The exterior of this elaborate facility uses a combination of composite metal panels and 3 inch AAC cladding and Elite Cements' Litewall basecoat and Acrytex finish coat. Elite's finish is also being used on a 1800 sq. ft. concrete wall. This finish application provides a uniform appearance for the facility which has very high visability from Interstate I-75, which runs parallel to the facility.

Interior Finish: The interior finishes are a combination of 5/8" drywall, slatwall, and unfinished concrete depending upon the functiion of the interior space.

Watch this space for this renovation project of a Harley-Davidson dealer in Piqua, Ohio.